GL.iNet

Nexus Telemetry Fleet supports GL.iNet’s firmware 4.8 and 4.11 on ARM routers. The firmware is built on OpenWrt and installs the collector with opkg. See Routers for the requirements.

The recording shows the collector installed through LuCI, OpenWrt’s web interface, and enrolled on a GL.iNet Beryl AX. See LuCI upload for the steps.

Supported firmware

Firmware Package manager Processor
GL.iNet 4.8 opkg 64-bit ARM, 32-bit ARM with hardware floating point
GL.iNet 4.11 opkg 64-bit ARM, 32-bit ARM with hardware floating point

Command line

The router’s admin page has no command line. Open an SSH session to the router as root, with the router’s admin password. The router’s default address is 192.168.8.1.

bash
ssh root@192.168.8.1

Install

The firmware’s opkg does not install a package from a URL. The command downloads the feed package first. Replace <channel> with the fleet server’s release channel.

bash
wget -O /tmp/nexus-fleet-feed.ipk https://fleet-downloads.nexustelemetry.com/openwrt/<channel>/nexus-fleet-feed.ipk && opkg install /tmp/nexus-fleet-feed.ipk && opkg update && opkg install nf-collector

On a router where the collector is not yet enrolled, the install ends with Nexus Telemetry Fleet collector installed. and the enrolment steps.

Firmware 4.11 checks package signatures. The feed package installs the feed’s signing key. Firmware 4.11 then accepts the collector.

LuCI upload

LuCI, OpenWrt’s web interface, installs the same packages without a command line. GL.iNet’s firmware does not include LuCI by default.

  1. Open System, then Advanced Settings, in the router’s admin page.
  2. Install LuCI.
  3. Open LuCI from the same page.
  4. Sign in as root with the router’s admin password.
  5. Follow LuCI upload with nexus-fleet-feed.ipk.

Enrol

Enrol the collector from a browser at http://192.168.8.1:41700, or with the enrol command. See Routers for the steps.

Firmware upgrades

A firmware upgrade with Keep settings keeps the collector, its device certificate and its record. The collector starts again after the upgrade, with or without a connection. It is still enrolled. About 2 minutes after the upgrade, the router’s package list includes the collector again. The collector updates from the feed as before. An upgrade without Keep settings removes the collector and its device certificate. Install and enrol it again.

Updates and bypass mode

  • Update on the dashboard first refreshes every package feed on the router.
  • With a Starlink terminal in bypass mode, the terminal’s own address, 192.168.100.1, is reachable from the router with no added route.